LUYOR-3103 Inspection UV LED lamp AC-Powered fixture.
UV-A blacklights are used for inspection of conformal coatings on printed circuit boards (PCBs) to check for uniform coverage.
UV blue tracer additive is incorporated within the formulation of the coating and glows bright fluorescent blue under UV blacklight. Any areas on the PCB not glowing reveals parts missed during the application of the coating e.g. conformal coatings on electronic circuitry for environmental protection and corrosion resistant metal coatings.
We offer a wide range of UV blacklight inspection lamps utilising both high intensity discharge (HID) bulbs and low pressure (LP) tubes and UV LED lamp from hand lamps and torches to large area flood lamps for checking the uniformity and correct location of conformal coatings.
Selection of UV light equipment should be optimised for a particular application and depends on the requirements for UV light irradiation area, UV light intensity, process integration, ambient light levels and temperature sensitivity.
Our luyor® technical solutions combine equipment selection recommendations with health & safety training and products. This ensures maximum performance benefits, safe use and confidence of the workers.
LUYOR-3103 Inspection UV LED lamp AC-Powered fixture. Intense 365 nm AC-powered black light fixture. Contains 3 Super 365 nm Emitters > 4500 uW/cm2 at 15".
LUYOR-3103 Inspection UV LED lampFEATURES: • New! AC-powered 365nm LED light fixture. • Voltage range 90-265V ac — works in USA and Europe. • True blacklight Alternate Light Source (no filter needed). • Nichia high flux emitter with special lenses (not reflectors!). • Output power density >5000μW/cm² at 15” (38cm). • Instant startup; instant re-start. • Beam diameter is 6x8” (at 15” working distance). • Current-regulated drive circuit maximizes output performance. • Air-cooled; no fan required. • LWD 4.50” x 3.375” x 3.375” • LED Lifetime 10,000 hours. • Beam angle 10 degrees with no hot-spots or rings. • Output power 3*325mW at 365nm peak. • Shows dust and contaminants unlike any other light this size! • Unbeatable for currency and document examination. • 8’ power cord; pushbutton power switch on rear of unit.INSTRUCTIONS FOR USE:
• Attach to suitable overhead surface. • Disconnect power when installing fixture. • Use caution to avoid direct exposure to eye. • Yellow or clear (appropriate UV blocking eg.
UV lights are often used to check PCB’s conformal coating. A conformal coating protects PCB’s from moisture, dust, and other environmental damage by providing a chemical barrier on the board. Many conformal coatings contain a UV trace, which will glow when viewed under a UV light. Because of this, UV magnifiers and microscopes can be used to find gaps in the conformal coating, and experienced inspectors can even validate the thickness of the coating based on the intensity of the glow.
Particle-Detection, Clean-Room-Inspection
UV inspection for particulate microcontamination detection
A wide range of UV blacklight fluorescent inspection lamps for particulate micro contamination detection processes.
UV blacklights for fluorescent inspection of:
- Clean rooms and controlled environments.
- Surfaces prior to paint or lacquer spraying.
- Non woven, medical grade textile products.
- Liquid crystal displays