Customer Service:
LUYOR Corporation
CHINA:
Phone: 4006-254-365
Fax: 021-51861392
Email: 574242291@Qqq.com
LUYOR-3401 True 365 nm UV LED Bulb
LUYOR-3401 True 365 nm UV LED Bulb. Super high-flux Nichia 365nm LED light bulb, E27 base, eimts > 1800 uW/cm2 at 15".
ULTRA VIOLET BLACK LIGHT BULB FEATURES:
--New! Screw-in 365nm LED light source (E27 base; 27mm)
--Voltage range 90-265Vac — works in USA and Europe.
--Works in any light fixture!
--True blacklight Alternate Light Source (no filter needed).
--Nichia high flux emitter with special lens (not a reflector!).
--Output power density >1800μW/cm² at 15” (38cm).
--Beam diameter is 6” (at 15” working distance).
--Current-regulated drive circuit maximizes output performance.
--Air-cooled; no fan required.
--Only 3 inches long.
--LED Lifetime 10,000 hours.
--Beam angle 10 degrees with no hot-spots or rings.
--Output power 325mW at 365nm peak.
--Shows dust and contaminants unlike any other light this size!
--Unbeatable for currency and document examination.
(*) Supported in fixtures with 75, 100, and 150W ballasts.
INSTRUCTIONS FOR USE:
-Screw in to standard light fixture.
-OR Screw in to ballasted light fixture to replace mercury vapor bulb.
-Turn off power when replacing blub.
-Use caution to avoid direct exposure to eye.
-Yellow or clear (LUV-30 OR LUV-10) glasses can be used.
-Not a toy keep out of reach of children!
UV blacklights for use in conjunction with fluorescent dye penetrants and magnetic particles for highlighting defects in metals and ceramics.Examples include; hairline cracks in aircraft landing gear, automotive steering systems and many other safety critical components on which our lives may depend.Defects literally jump out at the inspector due to the dramatic contrast between the bright glowing image of a defect against a dull background.
Widest range of UV-A blacklights for NDT crack detection processes from portable UV torches to flood lamps. Selection of UV-A blacklight equipment should be optimised for a particular application and depends on the following requirements:UV light irradiation area,UV light intensity,Process integration